Digital ID View 960H Series Instrukcja Obsługi Pobierz pdf (Strona 12)

2.2.11. Sensor Terminal Block

Connect sensors (dry contact type) with each ground (GND) line to “G” pin.

2.2.12. Alarm Terminal Block

Connect various alarm devices controlled by relay output.

Note

Support both N/O (Normal Open) and N/C (Normal Close) types of sensor. If connected sensor is not

functioning, ensure wiring is correct. The connection method may differ according to the type of P/T/Z controller.

Enquire to your vendor for guidance.

Note

No.

Sensor

No.

Alarm

No.

PTZ

2 Sensor 1

5 Alarm 1 (+)

1 RS 485 D+

3 Sensor 2

10 Alarm 1 (-)

6 RS 485 D-

7 Sensor 3

8 Sensor 4

4 Sensor Ground

9 Sensor Ground

2.2.13. Power Input

Before connecting the power cord to the system, check if the power is in accordance with the system specification.

2.2.14. Grounding Terminal

It is recommended for user to make grounding to protect the system against external electrical surge.

2.3 IR Remote Controller

In order to use IR Remote Controller, the ID of the IR Remote Controller must be same as the ID of the DVR.

(Default ID # for DVR and IR Remote Controller is “0”.)

If you have more than two DVRs, you are able to control them individually with just one remote controller by setting up

‘REMOTE ID’. (The Remote ID is adjustable from ‘0’ up to ‘255’.)

Procedure 1

‘REMOTE ID’ Setup in the DVR

To setup the “REMOTE ID” for IR

remote controller, firstly decide the

initial REMOTE ID in the DVR.

MENU  SYSTEM  SYSTEM INFO

 REMOTE ID

The Remote ID is adjustable from ‘0’

up to ‘255’.

For example, change ‘REMOTE ID’ to

‘99’ and click ‘SAVE’ to save the

changed setting as shown on the right.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 64 65

Komentarze do niniejszej Instrukcji

Brak uwag

Digital ID View 960H Series Instrukcja Obsługi Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Cyfrowe rejestratory wideo (DVR) Digital ID View 960H Series